After that, the configuration of your electrostatic powder spraying line was confirmed.You need to start thinking about some of the necessary parameters.It is roughly divided into the following parts：
1. The size of the workpiece.Welcome to visit Hanna powder coating Co., Ltd. www.coating-equipment.com
The size of the work piece determines the size of the spray room (powder recycling room) and the curing oven (oven) that you need. In the automatic spraying line and the semi-automatic spray line, the work pieces of the spray tunnel, drying oven, curing drying Road and powder recovery spray room are also determined by the scale of the mouth. These data are directly reflected. Ring your spray line energy consumption, area and investment quota.
2. The weight of a single piece.Welcome to visit Hanna powder coating Co., Ltd. www.coating-equipment.com
The weight of the single piece work piece is used to determine the size of the spray chain with different load-bearing capacity, and the heating power of the heating energy is combined with the expected daily output (the heavier the total weight of the work piece in a unit time, the more heat demand).
3, the expected daily output of the work piece.Welcome to visit Hanna powder coating Co., Ltd. www.coating-equipment.com
The output data of the workpiece is mainly used in the manual spraying for the further determination of the internal volume of the curing furnace (oven). In the semi-automatic and automatic spraying lines, the design and operation speed of the spray chain, the spray, the low temperature drying and the length of the high temperature curing link are mainly affected in the semi-automatic and automatic spraying lines, so the investment amount and the amount of the spray line are directly affected. Ground area and energy consumption.
4. The material and shape of the workpiece.Welcome to visit Hanna powder coating Co., Ltd. www.coating-equipment.com
Different materials may require different pretreatment processes or even different powders. Different shapes require different suspension, turnover methods, and higher performance electrostatic spray guns.
5, choose to determine the energy used for high temperature curing.Welcome to visit Hanna powder coating Co., Ltd. www.coating-equipment.com
Commonly used heating methods are: electric heating, fuel heating, coal heating, Guan Daotian hot gas heating, steam heating and other ways, these heating methods in one time investment, use consumption, automation, environmental indicators and other aspects of the characteristics; should be based on the energy situation in your place, power supply capacity of the factory area, environmental protection We can choose two or even more than two heating modes to adapt to different working situations. According to the current domestic energy situation, priority should be given to the heating system of coal gas (liquefied natural gas or natural gas) and coal fired heating system.
Choosing high efficiency, low energy consumption heating energy can save you tens of thousands or even hundreds of thousands of yuan of cost in a year.
Note: the heating system of the same energy, which is designed and produced by different manufacturers, has a considerable difference in the key parameters such as the utilization of heat energy, the degree of automation, the service life and so on. As a user, it should be carefully examined.
6. The area, height and shape of the plant, the location of windows and doors, the layout of power supply facilities, etc. Welcome to visit Hanna powder coating Co., Ltd. www.coating-equipment.com
The spray line process and equipment layout must be applied to your original plant as far as possible so as to avoid unnecessary investment.
Key words:powder coating line powder coating Manufacturer powder coating equipment
I hope that the article will help you.