Abstract: This paper briefly introduces the coating defects that are easy to occur during the powder coating process of spin-on oil filters and diesel filters. The coating defects were analyzed and a solution was proposed. introduction Spin-on oil filters and diesel filters have the characterist
Now Hanna Technology will introduce you to the maintenance methods of spraying equipment1. Finishing of paints and auxiliary tools: The remaining paint after use should be sealed and stored, and the auxiliary tools (mixer, testing tool, weighing tool, etc.) should be cleaned and stored.2, coating qu
Everyone knows that the powder spraying equipment needs maintenance. How should it be maintained? The editor of Hanna Technology will discuss it with everyone! !1 weekly protection and maintenance1.1 Powder supply: Clean up all the powder, clean it, and see if it is contaminated when looking at the
*Hanna manual conveyor system features:1. Based on customer demand, provide the corresponding optimal design2. Fine workmanship to ensure the stability of the conveyor track * How to design an optimal solution?1. Comprehensive analysis of customer cost budget and capacity requirements, select manual
The pretreatment method is divided into liquid processing and dry processing.Hanna offers you reasonable and economical pretreatment methods to clean your workpiece.According to the product size, different processing forms can be selected, the structure is reasonable and the ideal use effect can be
Quality Assurance Measures And Service Content.pdf
The problem of rust return between the pretreatment processes of the workpiece has become the most concerned issue for customers. After the workpiece is rusted, it directly affects the pre-treatment film quality, which in turn affects the coating effect. Therefore, how to do rust prevention between processes is one of the key tasks in pretreatment.
Common faults and analysis during electrostatic spraying 1. Host gun insurance blown (1A) 1A gun insurance2.When the spray gun enters the water, the high-voltage static electricity is short-circuited, the system is in protection, the output voltage is very low, and the spray gun is fully dried, and the water source is checked and disposed to ensure that the compressed air is monotonous.
One: cleaning of the electrostatic spray gun After use, the spray gun and its accessories should be cleaned immediately. Improper maintenance and cleaning will increase the incidence of spray gun failure.
The production of powder coating spray booth is the key process in the spraying production process. The key to the quality of the surface of the sprayed workpiece lies in the control of various process parameters during the spraying process. The amount of powder and atomized air are two key technical indicators.